Frequency of laser marking machine
The number of pulses per unit time is called the marking frequency of the fiber laser marking machine. This is a good understanding. When the marking frequency is large, the laser spot is dense, and if the marking frequency is small, the laser spot is loose. Although the naked eye may not feel it, if we put the marking place under the electron microscope, we can see that it is a continuous line in the eyes. It is composed of many points. The higher the marking frequency, the denser the laser spot and the smoother the marking.
The speed of the laser marking machine
This refers to the scanning galvanometer speed of the laser. This speed is the speed that can be adjusted in the parameters, not the overall speed at which a product is marked. Because the overall marking speed is not only affected by the adjustment of the speed parameters, but also by the marking depth, marking area and other factors. Marking speed The role of this parameter is that the faster the speed, the faster the marking speed. The speed is fast, and the number of times the laser is struck in the same place is less. Slow speed is more conducive to depth. But it is not the slower the speed, the better the depth. Because the speed of the marking is too slow, the material that the laser hits will accumulate on the surface of the material, affecting the laser to reach deeper. So if you are playing depth, you should use a high speed sweep after a few times at low speed.
Power of Laser Marking Machine
In the parameter setting, the power is adjusted in percentage, and the output power from 0% to 100% can be adjusted. The default default parameter is 50% of the output power. The larger the output power is, the larger the laser output energy is, and the easier it is to drill. However, the output power should be adjusted according to your actual needs, because the output energy is too large, the greater the impact on the material, you can achieve the desired effect without having to open more power, otherwise long time and high load Working, it will have an impact on the life of the laser. Filling is mainly used in closed graphs that are not related to each other. Fill types are: one-way fill, two-way fill, circular fill, and optimized two-way fill to adjust fill angle and line spacing, line margins. There is nothing to say about this parameter. Everyone actually knows what is going on (filling the lines in the graph).
Pulse Width of Laser Marking Machine
Pulse width is the duration of a pulse. The general fiber laser marking machine does not have the function of adjusting the pulse width. What are the advantages of the fiber laser marking machine with adjustable pulse width, which can be used to black alumina, and has a certain advantage in depth.
3D Deep Fiber Laser Marking Machine
Handheld Fiber Laser Marking Machine
Enclosed Fiber Laser Marking Machine for Metal
PVC UV Laser Marking Machine
