Recently, a team of researcher Wei Chaoyang from the Precision Optical Manufacturing and Inspection Center of Shanghai Institute of Optics and Precision Machinery (SIPM) of the Chinese Academy of Sciences (CAS) has realized the fabrication of high UV laser-damaged fused silica components based on the defects characterization and removal process of CO2 laser. The research results were published in Light: Advanced Manufacturing.
The problem of UV laser-induced damage to fused silica components has severely limited the development of high-power laser systems. The current contact grinding and polishing process inevitably has processing defects, which are difficult to be completely removed by post-processing, greatly reducing the performance and lifetime of fused silica components.
Based on the microsecond pulsed laser low-stress uniform ablation technology, the research team proposed a laser chromatography ablation method to characterize the subsurface defects, and coupled it to the rapid removal of materials to achieve the complete removal of subsurface defects at the grinding stage. Afterwards, the laser conformal cleaning method was used to clean the redeposited contaminants on the ablated surface, and laser melt polishing was used to smooth the ablation trajectory, realizing the CO2 laser full-link flexible processing of fused silica components. Compared with the conventional process, the CO2 laser processing link can effectively inhibit the introduction of processing defects and thus realize the preparation of fused silica components with higher damage thresholds. The proposed laser-based defect characterization and removal method provides a new tool for the study of subsurface defects and the formulation of suppression strategies, and also provides a new idea for the low-defect processing of fused silica components.
This work was supported by the National Key Research and Development Program of China, the Shanghai Yangfan Program, the National Natural Science Youth Fund, the Shanghai Natural Science Foundation, the Astronomy Joint Fund and the Young Innovation Promotion Association of the Chinese Academy of Sciences.
Progress in laser-assisted fabrication of fused silica components with high resistance to UV laser damage at Shanghai Institute of Optics and Mechanics (SIOM)

Fig. 1 (a) Conventional process link; (b) CO2 laser processing link; (c) 3D full-caliber subsurface defect characterization method
Advances in laser-assisted fabrication of fused silica components with high UV laser damage resistance at SIPM.

Fig. 2 Comparison of damage performance between conventional and laser-based samples: (a) 1-on-1 damage probability (355 nm, 8.3 ns); (b) typical damage morphology.





